Breadcrumbs

Minimum CVSS v3 Value for Defender for Endpoint

Connector Applicability

Applies to Source Connectors

MS Defender for Endpoint

Applies to Destination Connectors

All

Assumptions

These instructions assume you have already setup a source connection in CI Sync for MS Defender for Endpoint using the CI Sync instructions here: Add MS Defender for Endpoint.

Pre-Read

Syncfish recommend customers read the following documentation before changing the Connection Setting/s described below.

  1. Understanding the use of CI Sync Connection Settings

  2. Rule 10 - Minimum CVSS Threshold Value

Locating and Amending the Connection Setting in the CI Sync UI

  1. Navigate to the Settings page

  2. Under the Source Connections heading (list), locate your MS Defender for Endpoint connection.

  3. Click the Update link on the right hand side of the MS Defender for Endpoint connection.

  4. Scroll down and locate the Section Heading and view the Individual Setting/s.

CleanShot 2025-07-21 at 10.01.33@2x-20250721-000143.png

The screen shot is provided only as sample to assist when reading this page. The state of your own CI Sync UI will depend on whether you are starting from the CI Sync default position or if you have already amended one/more of the settings.

  1. Tick the Override default box/boxes and then use the sliders related to the individual settings. The following table elaborates any further information about these particular settings.

Setting

Type

Additional Notes

Minimum CVSS v3 Value

Number

A number between 0 and 10.

Only CVEs with a score above this value will be synchronized into ServiceNow.

  1. After modify the settings, scroll to the bottom of the page, tick the “I consent…” checkbox and finally click the Save connection button.

  2. You can now run a sync job and the amended settings will be applied causing the CI Sync Data Sync rules to be modified accordingly.

Importantly

Make sure you consciously override the setting against either your TEST or PROD environment (i.e. your TEST vs PROD sync jobs).

For more information on how to use TEST vs PROD Connection Settings please read Understanding the use of CI Sync Connection Settings.

Syncfish strongly recommend making changes for TEST environment/sync jobs first. Only modify PROD related settings after thoroughly validating the intended results in TEST.